Panel refastening
Backed out fasteners are swapped before they let water in.
A Oradell roofer can fix leaks on metal, rubber and shingle mobile home roofs, working with the light framing these homes are built on. One call to (551) 383-2310 reaches a nearby roofer who works on mobile homes.
A mobile home roof has its own weak points, and most leaks start at the same few spots. Older single and double wides often have galvanized steel or aluminum roofs on bowed trusses, and newer manufactured homes may have rubber membrane or shingles. On metal roofs, the seams between panels, the screws holding them down and the sealant around vents, skylights and the AC unit are where water gets in.
Water does damage quickly in a manufactured home. The thin materials used in many mobile homes stain, swell and grow mold quickly once they get wet. A ceiling sagging with water can be drained through a small hole into a bucket, away from any light fixture, with power to that area shut off at the panel if the panel is safe to reach.
Mobile home roofs are not built to be walked on like a house roof. Stepping between the supports can buckle the metal or damage the ceiling, so roofers stay on the truss lines. Never go up when the roof is wet or icy, and check the data plate inside the home, which lists the roof load zone the home was built for.
Depending on what the roofer finds, mobile home roof repair in Oradell, NJ can go hand in hand with roof coating and metal roof repair.
Dealing with this in Oradell, NJ right now? Call (551) 383-2310 to reach a nearby roofing contractor.
Call nowThe fix depends on the roof type and how far the water has spread.
Every seam, screw, vent and edge is checked, along with low spots where water sits. Stains on the ceiling inside help narrow down the source.
Backed out fasteners are swapped for new gasketed screws, often a size up so they bite into fresh wood. Surface rust is wire brushed and primed.
Seams and laps are cleaned, primed where needed and sealed. On rubber roofs, the roofer patches with matching membrane and lap sealant.
Vent caps, skylights and the AC curb get fresh sealant or new flashing, and cracked vent covers are replaced. The edge rail around the roof is resealed too.
On metal and some membrane roofs, a full elastomeric or silicone roof coating is applied after repairs to seal small gaps and reflect sun. The roof must be clean and dry for the coating to stick.
Backed out fasteners are swapped before they let water in.
Open seams are sealed with tape or fabric and coating so water stops getting through.
Water damaged areas are opened and fixed where water sat the longest.
Cracked vent caps are replaced to stop leaks at each opening.
A reflective coating covers the roof which slows rust on metal.
A full mobile home roof replacement is the answer when rust, rot or a worn membrane has spread across the roof. Depending on the home, the new roof may be metal, a single ply membrane such as EPDM or TPO, or shingles on a pitched roof. Rotted trusses are repaired or reinforced before the new roof goes on.
In Oradell, mobile home roof replacement plans begin with the data plate and the condition of the trusses. Ask whether a permit is needed, since manufactured homes can have their own rules. Done right, the new roof should end the cycle of patching.
A roof over leaves the old roof in place and builds a new one on top. The most common types are a pitched roof over with trusses and shingles or metal, a flat roof over with insulation board and a single ply membrane, and a metal roof over on furring strips. Most roof overs also add insulation, which helps with comfort and with the noise of rain on metal.
For an Oradell mobile home roof over, the roofer checks the walls and trusses, since the new roof adds weight and catches more wind. A pitched roof over changes the structure, so it often needs a permit and engineering, plus solid anchoring for wind. Done well, a roof over can stop chronic leaks and add years to the home.
In Oradell, many mobile homes still have their original low slope metal roof, while newer ones were built with shingles. Owners in Oradell and neighboring communities such as Emerson, New Milford, Haworth and Paramus often find that a well kept coating is the difference between a dry roof and a leaking one, and catching a leak early keeps ceiling panels and framing from rotting.
For mobile home roof repair in Oradell, NJ or nearby towns like Emerson, New Milford, Haworth and Paramus, call (551) 383-2310 to reach a roofer who covers your street.
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Oradell is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Oradell know the roof types and weather wear common in local homes.
Ask the roofer about the cause, the options and the estimate before work starts.
More questions? Call (551) 383-2310
A seamless coating over a sound but weathered roof, when the roof underneath is still dry and solid.
Learn moreRepairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, matched to exposed fastener and standing seam roofs alike.
Learn moreFixing open seams, punctures, shrinkage and split flashing on EPDM rubber roofs, after the real leak point is found.
Learn moreStopping water at the pipe boots, flashing, valleys and nail holes where roofs actually leak, before wet decking and insulation turn into rot.
Learn moreLooking for something else?
See all roofing servicesCall (551) 383-2310 for a local roofer in Oradell and nearby towns.