Framing repair
The base under the roof is made sound for a straight, solid roof.
Metal Roofing
Metal Roof Replacement Oradell, NJ
A roofer in Oradell can replace a metal roof that has rusted through, lost its finish or been riddled with worn screw holes, down to the purlins or deck, so the new roof is set up for decades. Call (551) 383-2310 to reach a local roofer.
Replacement comes up once rust or wear has spread past what patches and new fasteners can fix. Widespread rust holes, a worn-out finish and hundreds of stripped fastener holes mean the metal has done its job. Thin panels from decades past are usually the first to rust through.
Replacement can mean a full tear-off, a re-cover or panel by panel work. Stripping the old metal exposes the framing, which matters because fasteners in rotten wood will not hold. A re-cover, or retrofit, installs new metal over the old panels on new sub-framing, which is common on shops and large buildings.
Many metal roof replacements are actually shingle roofs getting metal for the first time. That job can be a full tear-off or, where code allows, metal laid over one layer of shingles. It helps to know what is on the roof now, how old it is and whether it has ever been covered over.
Metal Roof Replacement is often paired with metal roof installation and metal roof repair, depending on the cause.
Need metal roof replacement in Oradell? Call (551) 383-2310 to reach a nearby roofing contractor.
Call nowThe process
How metal roof replacement works
The order of work depends on tear-off or re-cover, but the basics are the same.
Inspect the structure
A full look at the panels, framing and attic shows whether the roof can be re-covered or must come off. This decides tear-off, re-cover or partial panel replacement.
Choose the approach
The new system is selected, whether exposed fastener or standing seam, and the method of replacement is settled. Switching to standing seam usually means adding solid decking.
Tear off
Old panels, trim and fasteners are removed and sorted for scrap metal recycling. The roof is never left open overnight.
Restore the deck
The structure is repaired so new fasteners bite into solid wood. New screws in rotten wood would fail within a few seasons.
Install the new metal
New underlayment, eave trim, panels, ridge cap and flashing complete the replacement. Gutters may be reset to match the new eave line.
What is included
Parts of a metal reroof
Tear-off
Failed panels and trim come off section by section.
Retrofit framing
A retrofit re-cover avoids a tear-off with fasteners driven into the structure below.
Flashing
Matching flashing at every edge instead of reusing old pieces.
Metal panels
The new metal system replace the old roof.
Related service
Metal Roof Panel Replacement Oradell, NJ
Metal roof panel replacement swaps out individual damaged panels instead of the whole roof. On exposed fastener roofs, the roofer removes the screws on the damaged panel and the overlapping edges of its neighbors, slides it out and sets a new one in sealant. Standing seam panel swaps are possible but slower, since the seams on both sides have to be opened.
For an Oradell building with one or two bad panels, panel replacement is often the sensible step. Color matching is the main limit, since new paint looks brighter than weathered panels. If many panels need swapping, a full replacement may make more sense.
Related service
Metal Roof Over Shingles Oradell, NJ
Putting a metal roof over shingles means installing new metal on top of one existing layer of asphalt shingles instead of tearing them off. Where code permits, the roofer adds underlayment or furring strips over the shingles and fastens the metal through to the deck.
The tradeoff is that nobody sees the deck. Before going over shingles on an Oradell home, the deck is checked from inside and any soft areas are found. If the deck is questionable or there are already two layers, a tear-off is the better choice.
Local help
Metal Roof Replacement Near Me
Around Oradell, metal reroofs range from rusted farm buildings to houses getting their first standing seam roof. Across Oradell and nearby communities including Emerson, New Milford, Haworth and Paramus, metal roofs that went decades without fastener work are the usual replacement jobs, which is why the condition of the purlins and deck drives the plan.
Searching for metal roof replacement near me from Oradell or Emerson, New Milford, Haworth and Paramus? Call (551) 383-2310 to talk to a roofer who works in your part of town.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Oradell is busiest after a hard winter and before the next one.
Why call
Why act early
Drier ceilings
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers who know Oradell
Roofers in Oradell know the roof types and weather wear common in local homes.
Clear next steps
Ask your questions before you agree to anything.
Common questions about metal roof replacement
Can a metal roof be installed over shingles?
Many codes allow metal over one layer of asphalt shingles. The upside is skipping tear-off, while the downside is not seeing the decking. Two layers or any rot means the shingles should come off.
Can a new metal roof go over the old metal roof?
A retrofit, or re-cover, installs new metal over the existing panels using a sub-framing system. It is common on larger buildings where tearing off would disrupt use. The structure has to be checked first, since the old roof stays in place and adds weight.
How is a single metal roof panel replaced?
Replacing one panel is a routine job on most ribbed and corrugated roofs. A new panel of matching profile and gauge goes in with fresh sealant and screws. Standing seam panels take more work because the seams must be opened.
What happens to the old metal roofing?
Removed metal panels are generally recycled. Unlike shingles, which usually go to a landfill, metal is sorted and sent for recycling. Your roofer can explain how the old metal will be hauled away.
When does a metal roof need replacing instead of repair?
Replacement makes sense once the metal itself is failing across many panels. Widespread rust-through, failed paint and stripped holes everywhere usually mean new metal. A call to (551) 383-2310 is a good way to find out where the roof stands.
More questions? Call (551) 383-2310
Other services that may help
Metal Roof Installation
Metal roof installation built around the right panel, finish and trim for the house, with high-temperature underlayment and proper flashing.
Learn moreMetal Roof Repair
Repairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, matched to exposed fastener and standing seam roofs alike.
Learn moreRoof Replacement
A complete new roof from the deck up when repairs no longer make sense, with the old layers removed and the deck checked.
Learn moreStanding Seam Metal Roof
Standing seam metal roofs with concealed clips, raised seams and no exposed screws in the panels, for homes, additions and low slope roofs.
Learn more
Looking for something else?
See all roofing servicesNeed metal roof replacement in Oradell, NJ?
Call (551) 383-2310 for a local roofer in Oradell and nearby towns.